✅ Polini swingarm bearing set – for Vespa single-sided swingarms from 1984 onwards
The Poliniswingarm bearing setis the perfect solution for overhauling the bearing between the steering tube and front swingarm on Vespa and Piaggio models with a single-sided swingarm. It is precisely at this point that enormous forces act from all directions – an intact bearing is essential for safe and precise wheel guidance.
The connection transmits the steering impulse directly to the front wheel and is therefore also TÜV-compliant. The bearings are fixed in place with pressed-in locking cramps. The bearing bolt is permanently installed in the steering tube, runs on needle bearings in the aluminum swingarm and is reliably sealed by O-rings and V-rings.
If the seals become brittle due to ageing, water can penetrate and destroy the needle bearings in the long term – an overhaul is then unavoidable.
Scope of delivery:
Complete bearing set for connecting the swing arm and head tube – suitable for all Vespa/Piaggio models with single-sided swing arm from 1984 onwards.
Technical data:
- ✅ Bearing bolt Ø: 16 mm
- ✅ Bearing bolt length: 56 mm
- ✅ Outer Ø of the bearings: 22 mm
- ✅ Including O-rings, V-rings and safety cramps
- ✅ Suitable for all Vespa / Piaggio models with single-sided swingarm from 1984 onwards
- ✅ Installation with a powerful press recommended
This bearing set ensures precise steering behavior, reliable sealing and maximum safety – ideal for everyday use, restoration or MOT preparation.
Reviews
There are no reviews yet.